[ARC5] Rollerductor setting

[Kenneth G. Gordon]

On 22 Apr 2017 at 16:11, J Mcvey wrote:

> 
> Good question I was not clear on the setup.
> The setup is a s follows:
> 
> Tx -> cap -> BC-442 (ammeter) ->unun -> coax-> wattmeter-> coax->dipole
> 
> The low current is in the unun lo-z primary.
> 
> The over-all Z is probably higher because the the reflected antenna reactance 
> becomes part of the primary circuit too.
> Interesting stuff...

Move the cap to AFTER the BC-442 and see if your current doesn't read higher.

Ken W7EKB

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus