[ARC5] My military headphones....

[Joel R Roberts]

Hi Ken, I have several of the high to low impedance connector converters 
if you need one. I in fact have four, three that are new and in the box. 
If you need one let me know.. Joel   KB0FPT
On 1/2/2015 12:11 PM, Kenneth G. Gordon wrote:
> OK. After further "research" it is looking as though my 'phones are either an
> HS-23 or an HS-33 set.
>
> The red PL-354 is on the end of the short cord, and when I use them with my
> FT-890, I get considerably more volume out of them than with my other set
> of phones, which have some sort of ANB-*** type elements, which are,
> obviously, higher impedance.
>
> Therefore, I am more inclined to believe these are the low-impedance
> HS-33s.
>
> I'll measure the DC resistance later today to see what I have. According to
> Mike Hanz' site, they should measure 60 ohms, if they are the 600 ohm
> types. We'll see.
>
> I also hope I am correct when I say that the pads I have been directed to by
> you folks, which are listed as fitting all mil phones, will fit these.
>
> Thanks,
>
> Ken W7EKB
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com