[ARC5] Spline Adapter

[john rose]

That collar is pinned very tightly to the sheetmetal. A lot of work if you are trying to reuse it.






From: Tom Bridgers
Sent: ‎Tuesday‎, ‎October‎ ‎28‎, ‎2014 ‎10‎:‎59‎ ‎PM
To: arc5





All,
Yeah, at first I couldn't figure it out. But one way to 
attach the adapter is to remove the threaded collar
that surrounds the recessed spline shaft.  I believe
it unscrews...  But I have seen some that have been
hacksawed off... :-(
 
Then you'd slip the adapter over the spline shaft, 
tighten the two set screws, put a knob on the 1/4 
shaft, and you're ready to tune the receiver.
 
Of course I could be completely wrong.
73,
-Tom  KE4RHH

 
                                       
______________________________________________________________
ARC5 mailing list
Home: http://mailman.qth.net/mailman/listinfo/arc5
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:ARC5 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html