[ARC5] ARC-5 Spline Shaft to Knob Shaft Adapter

[Phillip Carpenter]

You have to temporarily remove the top cover from the receiver and loosen the tuning capacitor from the front panel (4 screws). Then slide the capacitor and spline shaft back enough to tighten the set screws as you slide the adapter shaft through the ARC-5 shaft collar. Then put it all back and your good to go!

Respectfully,

Phillip

Sent from my iPhone

> On Oct 28, 2014, at 8:03 PM, hwhall at compuserve.com wrote:
> 
> Is it this one: 251696117639
> 
> I can't picture how the set screws are to be tightened onto the spline shaft as he described since (on all my sets) the spline shaft is recessed down inside the threaded cable collar. Or do you crank the set screws down & then jam the thing onto the shaft?
> 
> Wayne
> WB4OGM
> 
> -----Original Message-----
> From: Phillip Carpenter <carpenterpa at tds.net>
> To: <arc5 at mailman.qth.net> <arc5 at mailman.qth.net>
> Sent: Tue, Oct 28, 2014 2:30 pm
> Subject: [ARC5] ARC-5 Spline Shaft to Knob Shaft Adapter
> 
> There are some ARC-5 adapters on eBay from a guy who has made these to fit the 
> spline shaft on the tuning capacitor.
> 
> They work great!
> 
> Phil, W4RTX
> 
> Sent from my iPhone
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html