[ARC5] S+N/N ratio results.

[Roy Morgan]

On Jun 14, 2013, at 7:31 PM, Richard Knoppow <1oldlens1 at ix.netcom.com> wrote:

> …  one can just feed from a low impedance and assume the voltage will be close. I mean a terminated output from a 50 ohm generator is 25 ohms and will not be much affected when connected to a receiver with 200 or 400 ohms input.

I've thought about this and thought of taking the idea further:  

Make a nice "50 ohm" load for the receiver end of the cable with 50 and 0.5 ohm resistors, take the signal off the 0.5 ohm point and factor in the 100:1 voltage reduction.  Almost *any* receiver input impedance or resistance will get one hundredth of the voltage at the load end of the cable.

>   Leakage is a real problem.

The 100:1 divider would not help this: you'd be putting 100 times the voltage on the cable (and out some of the leakage points) than would be needed with an unterminated cable (receiver input 50 ohms) or 10 times the voltage if a 10 db pad is used.

I've read that the Collins lab procedure to check sensitivity was to hook the (50 ohm) generator output directly to the receiver with no terminating resistor or pad.  Included in what I read was the statement that the receivers had actual input impedances close enough to 50 ohms to make this work out right.

> ...   At any rate, getting an approximate measurement on a boat anchor is possible.

Oh, good!  I'd rather not thing that all this is in vain.

> A meaningful measurement on a receiver with fractional microvolt sensitivity is quite difficult.

I think that many reports of fractional microvolt sensitivity are suspect.

Roy
 
Roy Morgan
k1lky at earthlink.net
K1LKY Since 1958 - Keep 'em Glowing!