[ARC5] R-27/ARC-5 Hookup Question

[J. Forster]

Thanks. Mine is NOS...  right out of the box. No hacks.

-John

=============



> On 7/19/2013 3:08 PM, J. Forster wrote:
>
>>
>> 1 - GND
>> 2 - Phones
>> 3 - Sensitivity, 50k pot to GND
>> 4 - CW Osc, switch to GND
>> 5 - Screen N/C
>> 6 - + 24 VDC
>> 7 - +HV, N/C
>>
>> Is that it or am I missing something.
>
>
> Assuming your R-27 is stock, make sure it has a
> plug-in installed in the front.
>
> The +24V line runs from the rear panel, up to the
> connector box in the front of the receiver. Then
> from another pin on that box to the filaments and
> dynamotor.
>
> For the typical remote control installation, the plug-in
> had a jumper to make the 24V power connection, in
> a local control installation, the plug-in held the sensitivity
> pot and CW-OFF-MCW switch.
>
> The screen voltage connection was used in a test bench
> setup, it is not used in operation.
>
> Jack Antonio WA7DIA/4
>
>