[ARC5] Hewlett Packard Signal Generator HP-606B - Removing screws

[Richard Knoppow]

----- Original Message ----- 
From: "Leslie Smith" <vk2bcu at operamail.com>
To: "ARC-5 List" <arc5 at mailman.qth.net>
Sent: Thursday, March 01, 2012 4:28 PM
Subject: [ARC5] Hewlett Packard Signal Generator HP-606B - 
Removing screws


> Hello Group,
> I have a 1960's vintage signal generator I wish to use to 
> calibrate my
> ARC-5 "command" radios.
> The model:  HP-606B.

     You can also make a long wrench from a standard L 
wrench by cutting off the "L" and cementing the rest into a 
hole in the end of a length of hardwood dowel stock. I am 
sure there are other ways too.


--
Richard Knoppow
Los Angeles
WB6KBL
dickburk at ix.netcom.com