[ARC5] AN/ARC-3 RX alignment question

[Jack Antonio]

You had to go and make me dig my AN/ARM-1 out of storage. :-)

The MX-294 is a 680 ohm resistor in series with a 500 mmf
capacitor. Mechanically, the components are in a little
bakelite handle assembly with two female pins that slip
over the pins of the if transformers.


Hope this helps

Jack

Jack Antonio WA7DIA
scr287 at sbcglobal.net

John J Mccarty wrote:
> Hello;
> 
>   I got my ARC-3 receiver going and was thinking about aligning the IF. To align
> the over coupled stages the procedure calls out use of Shunting Unit
> MX-294/ARM-1. What is the shunting unit? My first guess would be just a shorting
> strap across the circuit that's not being adjusted, but it might be more complex
> than I'm imagining.
> 
> Tnx + 73
> 
> John n9hrt
> 
> _______________________________________________
> ARC5 mailing list
> ARC5 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/arc5
>