[Antennas] Connectors on LMR-400

[Don Keith]

Ron makes a good point.  I was just reminded of this while trying to install a new PL-259 on 9913 coax and actually pushed the center pin completely out of two new connectors before I shaved off some of the center conductor and made it work.  These weren't cheap connectors, either.  I've never had this problem with RG-8U or similar.
 
I'd bet somebody makes connectors that are a better fit for LMR-400...and 9913, too...and I will be on the lookout for some.  If anybody knows of any...
 
Don Keith N4KC
www.n4kc.com
www.donkeith.com
http://n4kc.blogspot.com 
 
David C. Hallam wrote:

> I have never used LMR-400 coax before and have a question about
> installing PL-259 connectors. Do I remove the Al shield from the foam
> that slides into the connector body. Or do I just leave it on and slide
> the body over the AL and under the braid.

   As as as I know the standard PL-259 connectors do not properly fit 
LMR-400 cable, check with the Times Cable website for details.
This information may apply to some version of LMR-400.
-- 
    Ron KA4INM - I'm proud to be Chuck's pop!