[Antennas] Rotator Identification

[Tim]

> First eliminate any 4 wire controls and rotors.   They are w/o a brake
> and good only for TV ants in the attic.

Well ... of the ones I have(rotors that is) only one is an 8 wire model  :-(
Unfortunately I have NO eight wire control boxes. Yet!


> The rotor control box should have stamped on bottom or back  CDE model
> no. and have 8 screw terminal points like the rotor has.
as stated previously I have no 8 wire controls ,,,


OK in reply to Dan's submission of
"http://users.erols.com/shiacawn/rotors/n_ident.htm"
in doing this "the actual rotor itself) must be removed to see this
identifying model stamp. On the bottom plate of the rotor itself, somewhere
near the terminal strip, you will find the model number and the date of
manufacture." am I in danger of scattering bearings everywhere or messing up
something I may regret later?

Going to get a couple out of the shed to take a look at.

BRB


---

File has not been scanned

Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.417 / Virus Database: 233 - Release Date: 11/8/02