[Antennas] 11 to 8 element cushcraft file..corrected file..

[Duane Hofstetter]

To do this conversion you need to remove 3 directors and trim one
director.  The remaining 6 directors then must be respaced.

The directors with the lengths of 35 7/8", 35 5/8", & 35 3/8"
should be removed.  The 35 1/8" director should be trimmed
the same amount on each side to a overall length of 34 3/4".
The remaining directors then should be respaced using the
drawing and dimensions below.


 |            |            |            |            |            |
|            |
 |            |            |            |            |            |
|            |
 |Spacing|Spacing|Spacing|Spacing|Spacing|Spacing|Spacing|
 |  #7      |  #6      |  #5      |  #4      |  #3      |  #2      |  #1
|
 |--------|--------|--------|--------|--------|--------|--------|
 |            |            |            |            |            |
|            |
 |            |            |            |            |            |
|            |
 |            |            |            |            |            |
|            |
 |            |            |            |            |            |
|            |
Dir       Dir        Dir        Dir        Dir         Dir     Driven
Reflector
#6        #5         #4         #3        #2         #1      Element


                         Dimensions
                         ----------

Reflector = 41"                      Spacing #1 = 14"
Driven Element = 38 - 38.5"          Spacing #2 = 11 1/2"
Director #1 = 36"                    Spacing #3 = 16 1/2"
Director #2 = 35 3/4"                Spacing #4 = 23"
Director #3 = 35 1/2"                Spacing #5 = 23 1/8"
Director #4 = 35 1/4"                Spacing #6 = 23 1/2"
Director #5 = 35"                    Spacing #7 = 30"
Director #6 = 34 3/4"


In cases of doubt about which elements are which refer to the
original Cushcraft assembly instructions.