[AMRadio] Switching ladder line...

Rick rickb at tx.rr.com
Fri Mar 11 16:20:16 EST 2011


The way my shack is set up I have an antenna matching device for each
station. The transmitters/transceivers are too far apart to physically reach
just one tuner for them all. If I can locate a rotary/wafer switch that will
accommodate the output of the Bauer 707 and BC-610's I would like to go that
route. The relay system would also work very well.

 

Thanks

 

  _____  

From: amradio-bounces at mailman.qth.net
[mailto:amradio-bounces at mailman.qth.net] On Behalf Of LEE BAHR
Sent: Friday, March 11, 2011 3:12 PM
To: Discussion of AM Radio in the Amateur Service
Subject: Re: [AMRadio] Switching ladder line...

 

If you were only going to use the feedline on two rigs,  I'd use a knife
switch.  (I find them at swap meets from time to time).  However, if you are
going to use this on more then two rigs, using a multi gang rotary switch is
the way to go.  Vacuum relays are just too expensive if you need a bunch of
them.

I am a little confused about your request.  In my shack I have open wire
line going to my Johnson Matchbox.  From there it goes to a multi position
Delta Coax Switch.  This switch then feeds the rigs.  If you have may rigs,
use more then just one Delta coax Switch.  I don't understand why you would
transfer open wire line to different rigs.  I transfer the coax input to the
tuner to different 50 ohm unbalance outputs to my different rigs.  I don't
have any open wire balanced output transmitters.  They are all 50 ohm
unbalanced rigs.

Lee, w0vt



Subject: [AMRadio] Switching ladder line...


> I'm looking for suggestions on how to switch ladder line between three or
> four different rigs without having to unhook it. I would like a
> configuration similar to a four pole coax antenna switch, but using ladder
> line. I've thought of using knife switches, but would like to hear how
> others have accomplished this. I'd like to run ladder line directly to
> each
> balanced tuner of each rig. Is anyone doing this and if so, how?
>
>
>
> Thanks,
>
> Rick/K5IAR
>
>
>
> ______________________________________________________________
> Our Main Website: http://www.amfone.net
> AMRadio mailing list
> Searchable Archives: http://www.mail-archive.com/[email protected]/
> List Rules (must read!): http://w5ami.net/amradiofaq.html
> List Home: http://mailman.qth.net/mailman/listinfo/amradio
> Post: AMRadio at mailman.qth.net
> To unsubscribe, send an email to amradio-request at mailman.qth.net with
> the word unsubscribe in the message body.
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Our Main Website: http://www.amfone.net
AMRadio mailing list
Searchable Archives: http://www.mail-archive.com/[email protected]/
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Post: AMRadio at mailman.qth.net
To unsubscribe, send an email to amradio-request at mailman.qth.net with
the word unsubscribe in the message body.

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html 

  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1204 / Virus Database: 1497/3500 - Release Date: 03/11/11

  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1204 / Virus Database: 1497/3500 - Release Date: 03/11/11



More information about the AMRadio mailing list