[AMRadio] Hammarlund HQ-170 Component Layout
Kim Elmore
cw_de_n5op at sbcglobal.net
Sat Dec 10 23:48:02 EST 2011
Ha! Well, I sure feel like a darned fool... It's right there, in the
stinkin' manual as a photograph instead of a diagram. I kept skipping
right over it, looking for a diagram. Sheesh!
Well, it's good be publicly humbled by one's own hubris now and
then... Now, back to the shop!
Kim N5OP
At 07:36 PM 12/10/2011, you wrote:
>I'm finishing up the alignment on my HQ-170 (it's not the A model).
>The manual I have is rather vague about the RF alignment procedure,
>which essentially sets the band spread so the dial is reasonably
>accurate across its range. It spends a lot of time on the 50-54 MHz
>alignment. I have an HQ-170A manual that has good component layout
>diagrams, much better than the original HQ-170 manual. However,
>Hammarlund apparently changed the component layout a bit when they
>went to the A, mounting some trimmer capacitors on top and changing
>the layout on the bottom.
>
>For example, I've discovered one discrepancy from the HQ-170 manual
>in that T1 and T2 in my HQ-170 are not "top slug for 455 kHz, bottom
>slug for 3056 kHz." Instead, it's top and bottom on T1 for 455 and
>top and bottom on T2 for 3056. I see no signs that anything was ever
>modified in this receiver as it was my Dad's and so I know it pretty
>well. He had marked T1 and T2 explicitly for what IF frequencies they
>covered, so he was aware of this oddity, too..
>
>So, does anyone have a diagram of which trimmer capacitor is which in
>the bottom of HQ-170? I'll also need a diagram of the antenna coil
>layout on top. When I started on the 15 m alignment, what the HQ-170A
>manual shows as the 15 m antenna coil doesn't act like the 15 m
>antenna coil when I adjust it -- it appears to be for another band.
>
>Kim N5OP
>
>______________________________________________________________
>Our Main Website: http://www.amfone.net
>AMRadio mailing list
>Searchable Archives: http://www.mail-archive.com/[email protected]/
>List Rules (must read!): http://w5ami.net/amradiofaq.html
>List Home: http://mailman.qth.net/mailman/listinfo/amradio
>Post: AMRadio at mailman.qth.net
>To unsubscribe, send an email to amradio-request at mailman.qth.net with
>the word unsubscribe in the message body.
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
More information about the AMRadio
mailing list