From kenw8ek at gmail.com Mon May 30 17:26:11 2016 From: kenw8ek at gmail.com (Ken, W8EK) Date: Mon, 30 May 2016 17:26:11 -0400 Subject: [Alinco] Alinco HF Xcvr, Desk Mic, PS FS Message-ID: Alinco HF Transceiver, Desk Microphone, and Power Supplies For Sale Alinco DX-70TH, HF + 6 m Transceiver: The Alinco DX-70TH covers 160 to 6 meters in SSB, CW, AM and FM. The receiver tunes 0.15-30 MHz and 50-54 MHz. The transmitter delivers 100 Watts. A narrow filter and pre-amp is standard. Other features include IF shift, dual VFOs, 100 memories, band and memory scan, CTCSS encode, attenuator and noise blanker. Please note that this is the "TH" model which has 100 Watts output on 6 meters, as opposed to the "T" model that only has 10 Watts. The DX-70TH includes the EMS-42 up-down hand mic, EBC-9 mobile mounting bracket, Owner's Manual and DC cord. It requires 13.8 VDC at 25 Amps. This particular unit is still in its original box. I can not say it is new for sure, as it came from a SK, but it certainly looks unused. Only $450. Alinco EMS-14 Desk Microphone: The Alinco EMS-14 desk mic is an electret condenser mic. The gooseneck may be adjusted to any angle. It features UP-DOWN tuning and there is an On The Air LED on the mic base. On the bottom of the mic base there is a gain control adjustment. There is also a switch for FM/SSB on the bottom. The mic cable terminates in an Alinco round 8 pin mic plug. Specs: 500~100K ohm. Output 0-30mW (RMS). Power consumption: 1.5ma RX, 2.5 ma TX. This particular mic appears to be new, still in its original box. These are selling in the $120 to $130 range. Buy this one for only $90. Astron RS-20 A, 20 amp Power Supply: The Astron RS-20 A is a very common power supply around most ham shacks. It provides 13 V DC for many ham rigs. Features: Solid State Electronically Regulated Fold-Back Current Limiting Protects Power Supply from ...excessive current & continuous shorted output Crowbar Over Voltage Protection Excellent Regulation & Low Ripple at low line input voltage. Heavy Duty Heat Sink Chassis Mount Fuse Three Conductor Power Cord Specifications: Input Voltage 105-125Vac Output Voltage 13.8Vdc (internally Adjustable 11-15V) Ripple Less than 5mV peak-peak (full load & low line) Continuous Duty 16 Amps; ICS 20 Amps Size 5" x 9" x 10-1/2" This particular supply works great. It only varies 0.01 Volts with a load! Cosmetically it looks great. With paper work for only $65. Kenwood PS-30 Power Supply: The Kenwood PS-30 power supply provides 13.8 VDC at 20 Amps intermittent or 15 Amps continuous. It features large heat sinks and automatic overload reset. Ripple voltage is less than 20 mv at 13.8 V DC 20 Amps. Input is 120 or 220 V AC. 7.2 x 5.3 x 11.5 inches The PS-30 has two output connections. It has a 6 pin molex connector as used on many, many Kenwood rigs, and also on many Icom, Yaesu and Alinco rigs. In addition there are screw terminals for lower current output, normally used for a 2 meter or dual band rig. This one works fine and looks great. Paper work is included for $100. I also have many other accessories available such as many different types of microphones, HTs, VHF and UHF rigs, HF and VHF/UHF antennas, connectors, miscellaneous accessories, etc. Just too many to list here. Please e-mail your requests. Prices do not include shipping from Florida. Thanks. 73, Ken, W8EK Ken Simpson E-mail to W8EK at FLHam.net or W8EK at arrl.net Voice Phone (352) 732-8400