[Alexandria Radio Club Reflector] Hal's stuff - KC4ZYP

[Hal T Miller]

               HAM & CB STUFF FOR SALE (Revised)                         
        
                      by Hal – KC4ZYP
               halmiller at juno.com    703-549-1506


1) ADI AR-147 FM 2 meter mobile (60/25/10 watts PEP) with plain
microphone. PL     
     tones & programmable including squelch/tone for relay functions for
use in a private 
     net group. Full modern features. With Manual.Great High Powered 2m
Mobile Radio!
     $100.00 (I paid $150 at HRO). 
     LARSEN 2meter 5/8 wave antenna & matching MNO magnetic mount. $40.00
     >>> $125 for both Radio & antenna with mount. <<<

2) ICOM 4AT Handheld 440Mhz (70cm).  Accepts IC-BP2,3,4,5
(7.2,8.4,9,10.8vdc)  
     battery packs (not included) & ICOM IC-DC1 Regulator (10.8vdc) for
use in car (not 
     included). Up to 2.3 watts output on High Power, 230 milliwatts
(0.230 watts) on
     Low Power. Simple Simplex or Duplex, + or – offset,  0khz or 5khz
frequency shift, 
     High or Low Power,  thumblewheel for frequency selection switches
for operation on
     70cm. No PL tones, but will accept a tone board & has a spare switch
for an optional 
     tone encoder. Sturdy & tough. Jacks for speakermicrophone or
separate microphone
     & external speaker. Great basic 440Mhz radio. With manual.
     $50.00.
     440Mhz mono antenna (Hustler?) & magnetic mount. $40.00.
      >>> $75.00 for both radio & antenna with magnetic mount. <<<

3) MFJ-9406X SSB 6 meter (10 watts PEP) with microphone. Lighted  
     Signal/Transmitter Meter. CW keyer jack (needs CW module). Volume,
Tuning & 
     Fine Tuning Knobs. Headphone jack. 10 watts output PEP. Tunes Ham
50.00-
     50.300Mhz CW/SSB portion & a little bit above & below this. With
manual.
     $125.00  (MFJ Sells for $279.95 new)

4) MFJ-9606X FM 6 meter (10 watts PEP) with microphone. TX & RX crystals
– 
     single channel. Optional (needed) PL tone circuit to access block
into 
     Microphone circuit for encoding PL tone for a repeater). Squelch &
Volume. 
     Microphone/TNC (for packet radio) jack. Two sets of crystals:
52.525Mhz TX & RX,
     52.1300Mhz TX, & 53.1300Mhz RX crystals for Alexandria Radio Club
Repeater. 
     $100.00  (MFJ Sells for $179.95 new). With manual.

6). Radio Shack HTX-10 (AM, SSB, FM) 10 meter mobile with microphone & 
     magnetic mount antenna. 25 watts PEP SSB/FM, 7 watts PEP AM. CB
magnetic 
     mount antenna tuned to 28.300-28.500Mhz Novice/Technician SSB
portion of 10
     meter band. Built-in 88.5 PL tone encoder only, but accepts PL tone
encoder or 
     encoder/decoder boards or modules (hooked up internally) for FM.
With manual.
.    $70.00
     
7) Uniden PC-244 AM/SSB CB Transceiver with a battery powered mobile 
     microphone & a desk microphone. It might make a nice 10 meter unit
if 
     modified (since it’s tuned to legal 4 watts AM/12 watts SSB, but has
25 watt finals).
     $50.00 or make offer.
 

7) Radio Shack (Realistic TRC-217, Model # 21-1644) 40 Channel AM
Handheld
    CB. Telescoping loaded antenna, Volume & Squelch. External antenna
jack (accepts
    RCA plug). Charge &  power jacks. Takes eight AA batteries including
rechargeables 
    for 12 VDC. Based on Input power at 12VDC (not PEP): 5 watts High
Output/ 2 watts
    Low Output. High/Low output switch. Push button lighted channel
indicator. No Noise 
    Blanker, but great for portable use on batteries or portable mobile
use with external 
    power (12-13.8 VDC) & antenna. Likely PEP is 4 watts High/ 1-to-2
watts Low.
    $25.00                                            

8) RC 121 Garrard - Antique Tube AM/FM Radio, with turntable in wood
furniture 
    chassis. Estimate to be 1956 model. Needs work. Tuning string needs
to be restrung.
    Powers up, but may need tube(s) replaced. Turntable, cartridge &
needle work when 
    hooked up to an external amplified speaker. Wood needs refinishing
and torn speaker
    cloth covers needs replacement or repair.  The Turntable Factory on
the web offers for
    $160 as listed on their web site to rebuild this model:  
    http://www.theturntablefactory.com/pricing.html
    $50 or make an offer.