[600MRG] Operation at KU4XR

[Andy - KU4XR]

Greetings all

After a 2 year hiatus, I decided to resume 630 meter operation. I finally found my " Round TUIT " and 
replaced the Xverter XTAL with a 10 MHz brick in the Oscillator and the benefit to that was immediately seen.
As expected, with stable frequency, decode numbers went up dramatically. In 2014, I installed an aftermarket 
VCTCXO in my Kenwood TS450S. in 8 years, it had drifted 3 cycles low, so I touched up the Osc. at 20 MHz,
and " zeroed " the 10 MHz brick; all to WWV. 
Moving forward, I hope to make TN. available to anyone who needs a contact this season, as my schedule allows.
I am low power at 22 watts TPO - Non-Linear but can now do the slower modes if needed.

73 and best DX to all this season:

Andy, KU4XR
Friendsville, TN EM75xr