[600MRG] Need OCXO wiring diagram

[J Mcvey]

 The spec sheet says that a 10K pot goes accross pin 2 ref and ground /case pin 5 with the wiper to pin 1 
Of coarse you need bypass caps  and a small choke in series with the supply.  should work.
http://www.n4iqt.com/ocxo/isotemp/OCXO131-2Spec.pdf    On Wednesday, September 18, 2019, 9:30:43 PM EDT, Andy - KU4XR via 600MRG <600mrg at mailman.qth.net> wrote:  
 
 Hi all:

Will anyone help me with the pin wiring, and needed componets ( values ) to use an Isotemp OCXO 131-191 ?

Pin-1 = V ctrl
Pin-2 = V ref
Pin-3 = +VDC ( 12 V )
Pin-4 = RF Out
Pin-5 = GND

I will use this to replace the Xtal Osc on my 630 meter Transverter. Thank you, and 73:

Andy - KU4XR
______________________________________________________________
600MRG mailing list
Home: http://mailman.qth.net/mailman/listinfo/600mrg
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:600MRG at mailman.qth.net

This list hosted by: https://www.qsl.net
Please help support this email list: https://www.qsl.net/donate.html
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/600mrg/attachments/20190919/c21a089a/attachment.html>