[600MRG] 50 vs 75 ohm coax, getting confused

[Ben Gelb]

http://tools.rfdude.com/RFdude_Smith_Chart_Program/RFdude_smith_chart_program.html

On Fri, Sep 7, 2018, 5:23 AM N1BUG <paul at n1bug.com> wrote:

> Is there any free and easy to use software which can be used to
> investigate the load R + X required at the end of a known length 75
> ohm coax to get 50 j0 at the source end?
>
> I'm getting myself confused. Nothing new there of course.
>
> Right now I have about 20 short pieces of 50 ohm coax spliced
> together going to the 2200m/630m transmitting antenna. This is a
> failure waiting to happen, especially since it is tightly stretched
> across the lawn to reach the antenna. Not to mention I am unhappy
> about moving it every time I have to mow the lawn. Naturally when it
> does fail it will be when there is four feet of snow over it.
>
> I had an idea to use 75 ohm coax to feed the LF/MF transmitting
> antenna. I have a lot of this stuff and it could be direct buried...
> out of harm's way and out of my way.
>
> I understand 50:75 ohm transformers are easy to make but there is
> the cost. Zero cost was the reason for wanting to use 75 ohm cable.
>
> Next I wondered if transformers are really necessary. It seemed I
> should be able to adjust the load R + X to get 50 j0 at the source.
>
> Then I realized this implies a non-zero X component at the antenna
> to get 50 j0 at the load. It could be significant at 630m where the
> line length is about 45 degrees. Running the antenna non-resonant to
> get this X component can't be a good idea. If I'm not mistaken that
> means lowered antenna efficiency, which is no good!
>
> So I'm trying to figure out whether using 75 ohm line is reasonable
> or just another of my really bad ideas which would lead to a whole
> new set of problems.
>
> At 2200m it might not be so bad, as the line length would be about
> 13 degrees. But even then, I'm not sure.
>
> If anyone can help me sort this out I would appreciate it. The more
> I think about it, the more confused I become.
>
> 73,
> Paul N1BUG
> ______________________________________________________________
> 600MRG mailing list
> Home: http://mailman.qth.net/mailman/listinfo/600mrg
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:600MRG at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/600mrg/attachments/20180907/5c959c55/attachment.html>