[600MRG] WSQ2 settings to decode WSQCALL (and WSQ2) at same dial as JT9 and wspr

[Neil Klagge]

For those who might want to try to decode ZL or VK on WSQ, here is my settings for using the DL4YHF version of WSQ2:


How I set up WSQ2 to use simultaneously with WSJT-X and WSPR on630m at w0yse



In WSQ2 (DL version*) With USB dial at 474.2 kHz…. use the following parameters…

Under SETTINGS: Change LOWEST TONE ON TX: to 1300 hz.
Under DISPLAY: Change WATERFALL FREQ RANGE…to whatever includes the area surrounding 1300-1380 with margins on either side of that. (I am using a wide waterfall from 800 to 2500 Hz for now).
Under DECODERS:
DECODER 1 BASE FREQ: …change to 1300 Hz
DECODER 1 SQUELCH LEVEL: …mine is 25-27 dB, but make it whatever works for you…
DECODER 1 (AND TX) MODE: …set to WSQCall 1.46xxx tone spacing (default)

All other settings can be left at default until you want to experiment with them (such as AGC under settings).

* Here is a link to DL4YHF’s extended version of WSQ2 ...
http://www.qsl.net/dl4yhf/WSQ/wsq_exe_dl4yhf.zip

I am running WSQCALL again using a dial of 474.0 which could decode you even if you are using WSQ2 with the above settings.


73 and GL
Neil, w0yse, CN85rq
Vancouver, WA

My ham radio websites: http://w0yse.webs.com/ and http://wg2xsv.webs.com
<http://wg2xsv.webs.com>
My Faith website: http://neilsfaith.webs.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/600mrg/attachments/20180304/8eb50c07/attachment.html>