[50mhz] Low Pass (TVI) filters FS

[Ken Simpson, W8EK]

Low Pass Filters For Sale:

Prevent TVI by putting one of these on your transmitter

Drake TV-3300-LP Low Pass Filter
This is a modern 50 ohm low pass filter to go between 
your transmitter and antenna, and has been optimized 
to have more attenuation in the 40 MHz region, where
many TVs have their IF. It is good for 1000 Watts
"average" according to the manual, and has over
80 db attenuation at 41 MHz.  SO-239 connectors
on each end. This one looks close to new, and also
has the single page "manual" with it.  $ 30

Drake TV-1000-LP Low pass filter 
This is the filter that is in the copper case, and may also 
be used on the low end of six meters, as well as HF.  It
is a 50 ohm filter and is good for 1000 W below 30 MHz, 
and about 200 W up to 52 MHz.  $ 30

B & W  FL-10/1500 (425)  low pass filter
B & W  TVI filter, 50 ohm. It cuts off just above 10 meters, 
and will handle 1500 Watts. SO-239 connector on each 
end. It is in very nice condition for $ 30.

MFJ 702 low pass filter
This filter is made to go on the output of your rig to
help get rid of TVI and harmonic interference.  It
is rated at 200 Watts, and is in a very study metal
case with SO-239 connectors on each end.  Operating
frequency is listed as 1.5 to 30 MHz.  It is a 50 ohm
filter.  This one works fine and looks very close to new.
These are $25 new, but you can have this one for $18

TVI bandpass filter, made by Communications Power, 
Inc in the USA. This is a bandpass filter for use on 10 (or 11)
meters, and is rated at 600 watts. It has provisions for tuning
the input and output for maximum TVI reduction. SO-239
connector on each end.  $ 30

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone  (352) 732-8400