[1000mp] FT-1000MP MARK -V frequency run away

Tue May 6 00:54:40 EDT 2014

check also mic cable...that it's not pinched or small buttons on mic
K
----- Original Message ----- 
From: "Mike Schatzberg" <cherokeehillfarm at earthlink.net>
To: <W70m at aol.com>; "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
Sent: Tuesday, May 06, 2014 3:57 AM
Subject: Re: [1000mp] FT-1000MP MARK -V frequency run away


> Check the rapid tuning ring (jog ring) around the tuning dial. Make sure 
> it is not hung up and is operating as it should.
>
> 73,
>
> Mike
> W2AJI
>
> Sent from my iPhone
>
>> On May 5, 2014, at 7:40 PM, Rod via 1000mp <1000mp at mailman.qth.net> 
>> wrote:
>>
>> Setup:  microHam micro Keyer II to FT-1000MP MARK V
>>
>> After the rig heats up the frequency begins to shifting down without
>> control.  Turning rig off sometimes resets it, only to ultimately start 
>> again.
>> Any ideas?
>>
>> 73
>>
>> Rod
>> ______________________________________________________________
>> 1000mp mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/1000mp
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:1000mp at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:1000mp at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html