[1000mp] FT1000MP MK V and MFJ 1026

[Tod -ID]

I have used it in the past. Works well. I have notes about its use on my
website www.k0to.us .

I think that you can use either PTT or TX Gnd to generate the signal to
switch the 1026.

If you are running high power and your AUX antenna is close to the TX
antenna you should be sure to have the small bulb in series with the AUX
input. Radio shack has [had?] replacement bulbs if needed.  

As I recall I modified mine to have an FET switch a relay that would ground
the AUX input when I was transmitting -- just a precaution.

Tod, K0TO



> -----Original Message-----
> From: 1000mp-bounces at mailman.qth.net 
> [mailto:1000mp-bounces at mailman.qth.net] On Behalf Of F4EUN
> Sent: Monday, March 08, 2010 10:27 AM
> To: 1000mp at mailman.qth.net
> Subject: [1000mp] FT1000MP MK V and MFJ 1026
> 
> Hello,
> 
>  
> 
> Does somebody use MFJ 1026 Noise Canceller and FT1000MP or MK 
> V, if you're using it which rear panel switch do you use for 
> PTT command ( PTT, TX GND or
> other) ?
> 
>  
> 
> Tnx fer your answer
> 
>  
> 
> 73  F4EUN Jérôme
> 
>  
> 
>  
> 
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:1000mp at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html