[1000mp] Re: it is the VCO nr 2

[Kathy and Jürgen]

Thanks Carlos, that is exactly what my MP does, It was just strange that 
it worked one day and all of a sudden nothing .
I will try to find and buy  a service manual and go from there maybe 
it's just a loose solder joint and not a defective component.
                                     73 Jurgen N9RD

smOkco wrote:
> The cure is to re-solder under the VCO nr2. in the Local Unit.
>
> Check    http://www.va3cr.net/1000MP/Problems/RepairsVCO.htm
>
> It is not difficult to do if you take care.
> Good table, good lights, patience.
>
> Best of luck
>
> 73 de cx7co  carlos
>
>
> --- Kathy and Jürgen <nittner at comcast.net> wrote:
>
>   
>> I have an FT1000MP which will not work from 7.500 Mhz to 14.500 (14 &
>> 10
>> mhz bands) no transmit ( of course TX would only work inside of the
>> bands)and no receive. All other bands are OK appears to
>> be a switching diode or transistor. Did anyone  run into this problem
>> before
>> and know how big of a job it is to repair?
>> The rig worked fine before this happened, I just went to work some
>> 160 and when I came back to 20m 2 days later it would not work. 
>>
>> Any help will be much appreciated.
>>                               Jurgen N9RD
>>
>>
>> ______________________________________________________________
>> 1000mp mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/1000mp
>> Help: http://mailman.qth.net/mmfaq.html
>> Post: mailto:1000mp at mailman.qth.net
>>
>>     
>
>
>
>       ___________________________________________________________
> Yahoo! Answers - Got a question? Someone out there knows the answer. Try it
> now.
> http://uk.answers.yahoo.com/ 
>
>
>