[1000mp] Roofing Filter

[Bob Main]

Checked the voltage and re-did the coax cables again and reset all of them 
and it is working now.  In fact I had to drop from 13 down to 11 or 10.  Man 
what a pain those little suckers are.

Thanks for the help.
Bob
KB4CL

----- Original Message ----- 
From: <cherokeehillfarm at earthlink.net>
To: "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
Sent: Friday, March 18, 2005 3:32 PM
Subject: Re: [1000mp] Roofing Filter


> Hello Bob:
>
> Use your VTVM and check that you have 5 volts on the connector between the 
> two pins you soldered into the board.  The connections are below the 
> board, and you can not see them, and if the solder flowed properly.  You 
> need to heat only the pretinned pin (a solid wire), while you gently push 
> it thru the hole, which already has solder in it.  If you have 5 volts on 
> the connector, check the jumper cable to be sure it is just fine.  If that 
> doesn't work, sounds like you have a bad transister on the board.
>
> Make sure your coax cables are inserted properly and fully.  They can be 
> difficult at times.
>
> Good luck and Happy DXing,
>
> Mike
> WB2AJI
>
> -----Original Message-----
> From: Bob Main <bobmain1 at alltel.net>
> Sent: Mar 18, 2005 12:24 PM
> To: MarkV <1000mp at mailman.qth.net>
> Subject: [1000mp] Roofing Filter
>
> Well I put in the roofing filter, NB mod and a 250 Hz filter.  I put it 
> all back together, plugged my Elecraft XG-1 to it and turned it and the 
> radio on.  Last week when I got the XG-1 the 50 uv signal gave me exactly 
> S9.  With the roofing filter in I got S5.  My 9-1 reading was 13 and so I 
> started increasing it.  After about 19 the reading stopped climbing and 
> never went above S7.  Any ideas?
>
> I've checked to make sure the two wires that I had to solder in were not 
> shorted to chassis ground or together.  I unplugged the coax going to 
> J2003 and plugged it into J1 of the roofing filter.  Then I took the 
> supplied coax and went from J2 of the roofing filter board back to J2003. 
> So all that is right.
>
> Got any suggestions?
>
> Bob
> KB4CL
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
>
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
>