[1000mp] 1000mp mk V and W2IHY

[R Hamment]

Hi Rob :
  With regard to the monitor , using your setup, the next step is to 
press SUB then NOR, monitor will then be 6K .If you want to go one step 
further  The camels hump audio response can be fixed by changing : 
R3016,R3017 from 10k to 2.2k and C3033 from 10uf to 100uf.on the AF 
board page75 in service manual.
2RX:  R8046,R8047 from 10k to 2.2k,and C8033from 22uf to 100uf. page 187 
in service manual.
Both receivers audio response then will be flat from 50hz to6k.

Regards Roscoe VK3KRH



Rob Atkinson wrote:

>> here's how I set mine up (these allow a Mk V to receive 6 khz wide
>> SSB and tx 3 khz wide for ragchew SSB operating):
>>
>> 4-4 Off (disable built in eq.)
>> 5-0 8.2-455 (remove 2nd IF filter and use 6 khz in 455 khz IF for rx)
>> 5-9 6 khz (select 6 khz filter for SSB DSP transmit)
>> 7-7 SSB rx off (turns off DSP in SSB receive)
>> SSB tx 100-3100 hz (turns on DSP and selects bw for SSB tx)
>>
>> of course if you want  3 khz rx, you can dial that in with dsp.
>>
>> I'd somehow get or borrow some kind of rx that you can use to listen
>> to your rf with.  the monitor isn't quite accurate enough to tell
>> what's really coming out of your antenna.  if you can tx into a dummy
>> load and listen with headphones on a nearby rx you will really know
>> what's gg on with ur mic, eq., etc.  doesn't necessarily have to be a
>> ham rig; a swl rx that takes SSB is useable.
>>
> the mk v speech proc. is pretty good when used sparingly.
>
>> rob/k5uj
>>
>>
>
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net
>