[1000mp] Sub Rcvr 500hz Filter Question

[Jim Smith]

Hi Frank,

Maybe you did this but, to engage the 500 Hz filter after you have set 
the menu options appropriately, you have to select it.  To do this, 
press and release the SUB button on the keypad and then the NAR1 button 
in the BANDWIDTH group beside the VRF/MEM knob.  You only get a few 
seconds to do this before the MAIN Rx takes over again.  To go back to 
wide band, hit the SUB button and then the NOR filter button.

Hope this helps.

73 de Jim Smith   VE7FO

frank60 wrote:

>I just finished installing all the optional filters in a new Mark V.  
>Everything seems to be working properly after I turned them all
>on using the various menu options except for the Sub Rcvr.   
>
>When I either turn on or off the sub receiver 500hz cw filter it
>makes no difference in receive.    It stays broadbanded whether
>the Menu 5-8 is On or OFF.   Did I miss something?   
>I am assuming you can listen on the sub receiver and then use
>the menu 5-8 to turn on and off the filter and hear the difference
>in receive bandwidth?    
>
>Anyone have any ideas?   Frank W7is  W7is@arrl.net   
>
>_______________________________________________
>List Moderator: Richard Lubash N1VXW
>1000mp mailing list
>1000mp@mailman.qth.net
>To Change Options or Unsubscribe:
>http://mailman.qth.net/mailman/listinfo/1000mp
>
>  
>