[1000mp] sticking relay problem

Mon, 22 Mar 2004 08:59:44 -0500

Try hitting the ANT A/B and RX buttons a few times - it's helped my MK V

Paul  W2LE

From: "FireBrick" <[email protected]>
Reply-To: [email protected]
To: "FT1000MP List" <[email protected]>
Subject: [1000mp] sticking relay problem
Date: Sun, 21 Mar 2004 20:58:06 -0600

Ok guys, I'd get the 'relay' problem now and then.
Especially after a long cw episode of trying to work a DX station.
Stop sending and it didn't 'fully' recover.
Could hear the station weakly, sub receiver seemed normal.
Tap the key for a 'dit' and it would return.

But today's pileups seemed to put it over the top.
Now it does not recover almost every time.
Hitting a 'dit' does not cure it every time.
and
Sometimes hitting a 'dit' will cause it to recover
but then the signals slowly dies down to the faint level.
It then takes a couple more 'dit' attempts to get it back
to full signal strength on receive.

So I heard a good report of a fellow in NC???
I've heard good reports about Burkhardt.
(will they service rigs not bought their?)

Anybody have any other suggestions.
I'm a feared of sending it to Yaesu and getting a
"Never heard of the problem and we can't duplicate it"

I'm open to suggestions, the rubber mallet technique didn't work.

-----------------------------------------------------
Honk if you want to see my finger.
-----------------------------------------------------

Bill H. in Chicagoland

_______________________________________________
List Moderator: Richard Lubash N1VXW
1000mp mailing list
[email protected]
To Change Options or Unsubscribe:
http://mailman.qth.net/mailman/listinfo/1000mp

_________________________________________________________________
Is your PC infected? Get a FREE online computer virus scan from McAfee� 
Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963