[1000mp] Question on Break-In button

[GRAEME JACKSON]

Dear John and Rick.
 
If you are intending to operate full break in, note that (in my opinion) you need to adjust the (switch to transmit) break in delay to say at least.....10ms to allow the relays to switch over so your not hot switching.  I think the default is 6ms which I dont think is enough !!!!!!!
It seems some people have had trouble with the relays in the front end........this could have been caused by the tx on switching delay not being enough.
 
All the best...........Graeme   (G4CKH)

Rick Stealey <rstealey at hotmail.com> wrote:
>What am I missing here.

John,
If you only wanted to operate QSK you could do what you suggested. But if 
you wanted to operate without QSK you turn off the Break0in switch, and you 
turn on the vox switch. This way the rig is not banging away on the relay 
with every dit and dah which your amplifier will thank you for. Or you turn 
off break-in and use the MOX button to manually switch to transmit, so you 
hear no receive noise until you turn it over to the other station. It all 
depends on the way you like to operate CW and the MP allows you complete 
freedom to have it your way.

Rick K2XT

_________________________________________________________________
Don’t just search. Find. Check out the new MSN Search! 
http://search.msn.click-url.com/go/onm00200636ave/direct/01/

_______________________________________________
1000mp mailing list
1000mp at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/1000mp