[1000mp] mixing inrad and yaesu filters

[Gorsline]

Tom - go to the va3cr.net site under the Mark V section and find my summary of
filter options for the 1000 family .  It has all of the Yaesu and INRAD units
listed with as much information as I could find on shape factors, etc.
[Anybody have any of the missing info? - please email me and I'll update]

FYI - Yaesu did have a 500 Hz crystal filter for the 1000D that will work in
the newer units.  Yaesu used Collins mechanical filters in the later MP rigs.
INRAD offers both crystal and mechanical options.

Mix and match is no problem.  If you can't fill all of the slots, start with
the 8.2 IF first.

Good luck.  73,  George VE3YV / K8HI

Thomas Beltran wrote:

> Subject: Re: [1000mp] mixing inrad and yaesu filters
>
> > I did what Earl recommends,  original 500 yaesu followed by Inrad 500.
> Put
> > the 400 cycle in the sub rx.
> > installed the inrad hiss mod while we were at it.
> >
>
> I've been thinking about filtering up for CW (I have the ssb filters).  So
> how would this work?
>
> 8.2 -  500   455 - 400
>
> 8.2 - 250   455 - 250
>
> and then 400 in the sub-receiver.  Are any of these Collins filters?
>
> Tom W6EIJ
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp