[1000mp] How to Access the 9 Series Menus

Thu, 12 Feb 2004 20:17:45 -0500

Unless I've missed somehting, it doesn't matter what you do as you power it
off, just what you do as you power it up.

>From the VA3CR.NET website

>> 1. Turn the radio with the FAST and the LOCK key pressed at the same
time.
>> 2. Press the FAST and the ENT key to access the menu

Once you power up the radio (step 1 above) the radio will appear normal,
it's just that after performing step 2 (which is the standard menu access
procedure) you'll find you can dial the menus past menu 8 to menu 9.

Mike N2MG

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of USA
> Sent: Thursday, February 12, 2004 5:18 PM
> To: [email protected]
> Subject: [1000mp] How to Access the 9 Series Menus
>
>
> FT1000MP MkV - I want to access the 9 series menus on my Mark V.
> I've had a
> couple of suggestions to do the following, which hasn't worked,
>
> 1 - Hold down the FAST and LOCK buttons and turn the main power
> switch off.
> 2 - While continuing to hold the FAST and LOCK buttons (under the VFO A
> knob) turn on the power switch.
> 3 - Rotate the VRF knob in the upper right hand corner to change to the
> specific 9 series menu.
>
> Well, after a master CPU reset and lots of messing around, all I get upon
> the power up sequence is a completely normal display. All the
> "normal" menus
> documented in the operators manual work fine, as does the radio.
>
> Any suggestions would be welcome.
>
> Dean, K9FTB
> Fairport, NY