[1000mp] Help InRad Key Click mod

[Art Searle W2NRA]

I found the problem and boy am I dumb!  In turning
the radio over and over I accidentally moved the
width control all the way to one side.  Thus no
signal in either nar filter position.  Ok let me
explain.  I had quite a bit of doubt in my
installation of the mods.  I don't have a lot of
confidence in my electronic ability.  I am an
accountant.  I am an amateur amateur.  I'm close
to 60 and I have entirely too much hand shake for
my age.  You should have seen me trying to solder.
Also my eyes aren't too good even with my
magnifier.  This makes it very difficult to check
for solder bridges.  In short, I'm falling apart
and I need a nice sedentary hobby like ham radio.

73,

Art

W2NRA


> Help!
>
> I'm having trouble with the InRad Key Click mod.
>
> Today, before I installed the Key Click mod I
did
> the IF mod and the Bonus mod.  I tested the
radio
> and all worked fine.
>
> Then I installed the Key Click mod.  The radio
> works fine except that the CW filters don't
work.
> I have no optional SSB filters in it but I do
have
> all of the CW slots filled, 500 and 250.  For
the
> record, when working on the filter board I only
> removed the 2 ribbon cables and folded it over
> onto a towel to work on the bottom.
>
> Any ideas?  Where should I look?
>
> Art
> W2NRA
>
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> 1000mp@mailman.qth.net
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>