[1000mp] FT-1000mp will not switch to transmit - help...

Fri, 12 Sep 2003 10:05:50 +0300

It's looks as PTT line is active (grounded). There are three reasons:

1. external device plugged to PTT on rear panel or in front to MIC jack.
2. broken MOX knob (if you use it very often)
3. some transistors inside MP which connected to PTT line 

73 de Vlad UA2FF
----- Original Message ----- 
From: Garry Shapiro <[email protected]>
To: <[email protected]>
Sent: Friday, September 12, 2003 9:31 AM
Subject: RE: [1000mp] FT-1000mp will not switch to transmit - help...

> Have you removed everything plugged into the MP and then powered it up?
> 
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Jim Dawson
> Sent: Thursday, September 11, 2003 10:38 PM
> To: [email protected]
> Subject: [1000mp] FT-1000mp will not switch to transmit - help...
> 
> 
> My MP was working fine until I turned it on the other day. 
> Now it will not switch to transmit. I have tried MOX, VOX, 
> PTT, CW keying, but it just stays in receive. The only way
> to get it to transmit is to push the "Tune" button. Once that 
> switches it to transmit, the only way to return to receive is to
> turn the radio off and back on.
> 
> I reset the CPU and that didn't change anything.
> 
> Has anyone else had this problem and if so, what was the
> cure.
> 
> TNX de,
> Jim - K9DD
> 
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
> 
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp