[1000mp] New MARK-V
Dennis
[email protected]
Sun, 16 Mar 2003 15:45:06 -0500
Hi Vidi,
At this time a fair comparison would be hard to make given that I have just
installed the INRAD filters in the MARK-V and have not had it on the air
yet. At best I am a casual CW OP with inspirations of becoming a good
one....HI In comparison with a friends MP who is a CW contester the MP
wins hands down every time as far as weak signal reception goes. The TS-2000
is a great rig but the receiver on the MP is a cut above the rest at this
time. I'll let you know after I have time to learn the new MARK-V but for
now it's a keeper.
73,
Dennis AB8NI
----- Original Message -----
From: "Vidi & Hester" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 16, 2003 3:09 PM
Subject: Re: [1000mp] New MARK-V
> Hi Dennis
> I am also a newcomer to FT-1000 and have a MP since Dec last. Interesting
> to note that you have or had a TS-2000. How does the MARK-V compare to
the
> 2000on receive - - - especially weak signals ? I am a 99% CW operator and
> must say the MP is great. I also have a TS-930 which is a very fine rig,
> but it lacks the refinement of the MP especially the second RX is
> unbelievable.
> 73
> Vidi, ZS1EL
>
>
> ----- Original Message -----
> From: "Dennis" <[email protected]>
> To: <[email protected]>
> Sent: Sunday, March 16, 2003 4:10 PM
> Subject: Re: [1000mp] New MARK-V
>
>
> > Hi Tom,
> >
> > Yes the VOX is "ELEMENTARY" and that's the first thing I should have
> > done....but I didn't.....DUH. All is fine with the VOX depressed and
I'm
> a
> > bit RED in the face. My TS-2000 would automatically go to VOX in the CW
> > mode and I just didn't think of it with the MARK-5. Sorry for the post
> and
> > waste of your time, mostly new rig jitters I think.
> >
> > Thanks and best 73,
> >
> > Dennis AB8NI
> >
> > ----- Original Message -----
> > From: "Thomas Worthy" <[email protected]>
> > To: <[email protected]>
> > Sent: Sunday, March 16, 2003 8:33 AM
> > Subject: Re: [1000mp] New MARK-V
> >
> >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > Dennis,
> > >
> > >
> > >
> > > Do you have the VOX button depressed? This sounds elementary but, we
> have
> > > to start somewhere.
> > >
> > >
> > >
> > > Tom
> > >
> > >
> > >
> > > Dennis wrote:
> > >
> > >
> > > Me again Tom,
> > >
> > > My MARK-V won't key (in CW) unless I have the "BK-IN" button pressed.
I
> > get
> > > the CW side tone but the rig does not key. Any ideas?
> > >
> > > Thanks,
> > >
> > > Dennis AB8NI
> > >
> > >
> > > ----- Original Message -----
> > > From: "Thomas Worthy" <[email protected]>
> > > To: <[email protected]>
> > > Sent: Saturday, March 15, 2003 6:28 PM
> > > Subject: Re: [1000mp] New MARK-V
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > Dennis,
> > >
> > >
> > >
> > > It sounds like you are having a lot of fun. The one that you want is
> 7-5.
> > > You just have to delay it a little.
> > >
> > >
> > > I also installed the INRAD filters and they work great.
> > >
> > >
> > >
> > > Keep me posted as to how you like it when you get it set up.
> > >
> > >
> > >
> > > Tom
> > >
> > >
> > >
> > > Dennis wrote:
> > >
> > >
> > > Hi Tom,
> > >
> > > Thanks for the reply and I think I found the menu (7-5) Keyer Delay
Time
> > >
> > >
> > > but
> > >
> > >
> > > see there is also one named Keyer Break-in Time (7-4). I'll be
> > pulling
> > >
> > >
> > > the
> > >
> > >
> > > rig out tomorrow to install the new INRAD filters that just came
so
> > I'll
> > > hook up the 1500 after that and play with the delay.
> > >
> > > Thanks again and best 73,
> > >
> > > Dennis AB8NI
> > >
> > >
> > > ----- Original Message -----
> > > From: "Thomas Worthy" <[email protected]>
> > > To: <[email protected]>
> > > Sent: Saturday, March 15, 2003 3:17 PM
> > > Subject: Re: [1000mp] New MARK-V
> > >
> > >
> > >
> > >
> > > Dennis,
> > >
> > > You will probably have to set the keying delay. It is not long enough
> > > to keep the 1500 keyed. You will find it in the menu. If you have any
> > > trouble finding it, let me know.
> > >
> > > Tom
> > >
> > > Thomas Worthy wrote:
> > >
> > >
> > >
> > > Dennis,
> > >
> > > I have a 1500 and Mark V and that is all that I did.
> > >
> > > Tom, W7YW
> > >
> > > Dennis wrote:
> > >
> > >
> > >
> > > Hello gang,
> > >
> > > I just received my new MARK-V and I'm a bit confused about hooking up
> > > my Ameritron AL-1500 amp. Can I just turn on the "LIN" switch and go
> > > from the "TX GND" jack to the AL-1500? The AL-1500 relay jack is
> > > rated 12V DC 100ma when pulled to ground.
> > >
> > > Thanks,
> > >
> > > Dennis AB8NI
> > >
> > > --- StripMime Report -- processed MIME parts ---
> > > multipart/alternative
> > > text/plain (text body -- kept)
> > > text/html
> > > The reason this message is shown is because the post was in HTML
> > > or had an attachment. Attachments are not allowed. To learn how
> > > to post in Plain-Text go to: http://www.expita.com/nomime.html ---
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > >
> > >
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > >
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > --- StripMime Report -- processed MIME parts ---
> > > text/html (html body -- converted)
> > > The reason this message is shown is because the post was in HTML
> > > or had an attachment. Attachments are not allowed. To learn how
> > > to post in Plain-Text go to: http://www.expita.com/nomime.html ---
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > >
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > --- StripMime Report -- processed MIME parts ---
> > > text/html (html body -- converted)
> > > The reason this message is shown is because the post was in HTML
> > > or had an attachment. Attachments are not allowed. To learn how
> > > to post in Plain-Text go to: http://www.expita.com/nomime.html ---
> > > _______________________________________________
> > > List Moderator: Richard Lubash N1VXW
> > > 1000mp mailing list
> > > [email protected]
> > > To Change Options or Unsubscribe:
> > > http://mailman.qth.net/mailman/listinfo/1000mp
> > >
> >
> >
> > _______________________________________________
> > List Moderator: Richard Lubash N1VXW
> > 1000mp mailing list
> > [email protected]
> > To Change Options or Unsubscribe:
> > http://mailman.qth.net/mailman/listinfo/1000mp
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>