[1000mp] INRAD Filters

[1000mp@mailman.qth.net]

When you install the Inrad 1000 Hz CW filter into slot 3 (normally used for
2000, 2100 or 1800 Hz SSB filters) the offset is not correct for CW. It may
be altered via the menus, and the User key and be used to select this setup,
or use the Shift key.

Inrad made a very good overwiew of their filters and the options in the
FT-1000 (D, MP, Mark V and Field).


73, Hans Remeeus.
Ham Radio: PA1HR
www.remeeus.nl

Communication is about people, the rest is technology.


----- Original Message -----

> Mike, N4EPD wrote:
>
> "I know this has probably been asked before, but in the FT1000MP can you
> put the Inrad 1.8 mhz. SSB 2nd and 3rd IF filters in the 250 khz 2nd and
> 3rd IF CW slots and without any realignment ??"
>