[1000mp] cw tuning indicator

[Billy Cox]

>The CW tuning indicator on my MP is not active.  I was able to get it to
>work with a signal generated by a QRP radio in the same shack, so it
>appears to work, but it's sensitivity is very low.

The other data point here is that the indicator may be set for a sidetone
that is different from what you prefer there ... <off hand I can't recall
the
factory default, another birthday just passed ... fewer working gray cells!>

>Is there an adjustment someplace inside or on a menu that will make it
>respond to normal received signals?  (note I once replaced the audio
>board myslef and have made no adjustments on the audio board, perhaps
>there are some that ought to have been made?)

Yes ... the trim tab is under the top "trap door" ... and check the early
archives for details. As I recall what I did was use the 'signal' from one
of the internal MENU settings <where you can adjust the tone to your
liking> and used that to readjust the CW TI to "center" at a much lower
sidetone, say 450 like I use here.

If you can't find the details in the archives, let me know and I'll see if I
made any notes in my service manual. Tweaking this may help, but the
CW TI is not that great a "bell/whistle", but sometimes is quite handy ...

73 Billy AA4NU