[1000mp] Power drive potmeter

Tue, 17 Sep 2002 20:43:35 +0200

Hello Philippe!

Be VERY carefull with such high RF Power Output levels. I would certainly
not advise this!

Here is your solution:

---
Preset the RF PWR control fully clockwise, and tune the transceiver to
14.2000 MHz. Select CW mode, key the transmitter and adjust VR3003 for 100
Watts on the meter.
---

You will find VR3003 on the AF Unit.

VR3007 = 50W & 10W RF Power Output
VR3006 = 50W & 10W RF Power Output
VR3003 = Overcurrent ALC Maximum RF Power Output
VR3002 = 50W & 10W RF Power Output

If you have any further questions, just send an e-mail to this reflector.

Good luck and 73!
Hans Remeeus.

Ham Radio:
PA1HR

Sites:
www.remeeus.nl
www.qsl.net/pa1hr

e-mail:
[email protected]

----- Original Message -----
From: "ON4VP" <[email protected]>
To: <[email protected]>
Sent: Tuesday, September 17, 2002 8:15 PM
Subject: [1000mp] Power drive potmeter

> Can anyone tell me where I have to look for the level potmeter to adjust
> output power.
> I have 140 to 160 watt on all bands when RFPWR knob fully clockwise, this
is
> to much.
> I guess the previous owner did alter this for no good reason at alland I
> want it back at 100 watt max key down.
>
> Thanks in advance,
>
> Philippe ON4VP
>
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>