[1000mp] FT-1000MP Update New Info - Scanning Between Frequencies P1-P9

Thu, 30 May 2002 13:48:47 -0400

Your Welcome Bruce, I love the sharing nature of this group!

Latest tip update about P1-P9 Memories:

While playing on my MP after reposting the previous message about the MP
memories and the P1-P9 Scanning features in particular.... I noted that I
could not get my P1-P9 memories to display at all, with Fast enabled or
disabled. Wow, was I surprised!!

Turns out that with the Mem Group button enabled, the P1-P9 memories will
not be selectable, even with data stored in them. When the Mem Group button
is active, you will see GROUP lighted under the Ant A B section of the
display panel. Turn that off, and the P1-P9 Scanning memories are available
again.

Even after all this time, still learning stuff on this great radio! Hi Hi

73 from Bill - WD8ARZ
[email protected]

----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Thursday, May 30, 2002 11:33
Subject: Re: [1000mp] FT-1000MP Tip of the Month - Scanning Between
Frequencies - Repost

> Great tip Bill. That explains why "My memories work the same with either
> setting of the FAST button."  In fact they do not. I just had frequencies
in
> all of the memories tested so I did not see any difference.
>
> Bruce  AA4Z