[1000mp] Compressor and output power

Mon, 6 May 2002 22:17:35 +0200

Hello Ferdy,

I use the FT-1000MP Mark V in combination with the TL-922, with very good
results.

Please use the ALC on the backpanel of the TL-922 and use the right
ALC-cables between the FT-1000MP and the TL-922. Then you don't have to
adjust the powersetting on the FT-1000MP anymore. Just use maximum power on
the FT-1000MP and tune the ALC on the backpanel until you get the power
output you want from the FT-1000MP.

With the Mark V I adjusted the ALC for about 45 Watt Class A input. It gives
me more then enough power output from the TL-922.

Using the ALC you don't have to bother anymore about the power output of
your FT-1000MP.

For tuning the Mark V I use the FH-1; this is very comfortable!

Good luck and 73!

Hans Remeeus.

e-mail: [email protected]
site: www.remeeus.nl
Ham Radio call: PA1HR

----- Original Message -----
From: "De Martin, Ferdy" <[email protected]>
To: <[email protected]>
Sent: Monday, May 06, 2002 11:28 AM
Subject: [1000mp] Compressor and output power

>
> With my 1000mp I use the Kenwood TS922 amplifier
>
> On 10mtb I try to keep the power under 500w, I use for that the RF button.
>
> I tune on FM with 15w and when I go SSB on same RF position the power
> go always over 700 800w due to the Comp level (around 12 o'clock position)
>
> If I put less output power from the MP the amp dont work...
>
> Any setting idea???
>
> Ferdy [HB9DSP]
> www.gtoevolution.ch/hb9dsp
>
> _______________________________________________
> List Moderator: Richard Lubash N1VXW
> 1000mp mailing list
> [email protected]
> To Change Options or Unsubscribe:
> http://mailman.qth.net/mailman/listinfo/1000mp
>