[1000mp] Fw: [Yaesu] A possible problem with FT1000MP

Thu, 10 Jan 2002 17:47:37 -0500

You might search the 1000MP archives. I have seen this question answered
before. Unfortuately, I don't recall the answers.

73,

Gary W2CS

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Juha Rantanen
> Sent: Thursday, January 10, 2002 9:28 AM
> To: FT1000MP mailling list
> Subject: [1000mp] Fw: [Yaesu] A possible problem with FT1000MP
>
>
> I already sent this to Yaesu mailing list but 1first two repliers
> said that
> I should turn into you folks. Few definitions: I did set up the
> new filters
> in the menu system and I don't think this has anything to do with the new
> filters as I also noticed the difference mentioned below with 2,4kHz wide
> filter.
>
> Juha OH6XX
>
> > Hi all
> >
> > I installed Inrad CW filters yesterday to my MP and noticed
> something that
> I
> > haven't noticed before. I don't think that the filters have
> anything to do
> > with it but I noticed that signal levels on my main-RX are quite about 2
> > S-units down from the sub-RX. I tuned around 7040kHz and found
> some stable
> > noice source and when I listened the signal on main-RX and immediately
> > switched to sub-rx the signal level was clearly down on main-rx. The
> signal
> > levels are concluded from the two S-meters MP has, of course they might
> not
> > be calibrated with each other but anyway the situation seemed to be like
> > this also by ear. Has anyone noticed anything similar or is my radio
> broken.
> >
> > Juha OH6XX
> >
> > P.S. Yes, I had the same filter bandwith on both receivers and all the
> > buttons seemed to be like should be.
>
>
> _______________________________________________
> 1000mp mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/1000mp
>