[1000mp] Band Data Jack

Sat, 29 Dec 2001 20:28:58 -0500

It's a BCD encoded representation of which band you are on.  Can be used by
devices to auto track band changes.  I use the output to automatically
switch my antennas when I switch bands.  YAESU use it for band switching
their amplifiers.

I cannot put my hand on the pinout data but as I recall it was a standard 1
2 4 8 binary code

Paul VE3SY

|-----Original Message-----
|From: [email protected]
|[mailto:[email protected]]On Behalf Of Ron Kenwood
|Sent: December 29, 2001 7:54 PM
|To: [email protected]
|Subject: [1000mp] Band Data Jack
|
|
|I am confused about what goes on at the band data jack. What appears on the
|pins labeled Band Data A through D? Also is there a list of the voltage
|levels for each band? If I missed something in the manual, just a page
|number would be fine.
|
|73, Ron
|W3ZV
|_______________________________________________
|1000mp mailing list
|[email protected]
|http://mailman.qth.net/mailman/listinfo/1000mp
|
|